CoolerMaster Stacker, VapoChill LS, AMD FX-60 X2, DFI Lan Party, GeIL PC4400 Ultra-X, 4 76 gig WD raptors raid-0, 4 500 gig maxtors sata, 2 XFX 7800 GTX's SLI, Mad-Dog DVD/R/RW, Sunbeam fan controller, TurboCool 1000watt top and ThermalTake 680watt bottom. This was a much easier fit then putting the VapoChill XE in the bottom of the case, plus much more room for hard drives. I started by removing the screen on the bottom. Also a nice place to run lines through when water cooling.
Then I removed and cut the front plastic nose to fit over the VapoChill LS case.
There are if few lugs on the bottom of the case, so I added a layer of neoprene to close up the gap. Put the now moded plastic nose back on. Drilled the holes from the template provided by VapoChill. Took metal snips and cut the case to the side so the evaporator would fit along side the bottom power supply. Then I held the VapoChill LS up against the bottom to check all the holes and to make sure it fit in the nose of the coolermaster case.
Next I sat the cast on top the VapoChill LS all was good screwed it down and attached the chill control board.
I had the bottom ThermalTake 680w turning on the VapoChill LS so I made and added this plug. So I could start the case fans and VapoChill before I started the rest of the system. This works great when your trying to get your best overclock. Take it down to -70C before you even boot up!
Board in, vapochill in, cpu in and insulated, almost done.
Adding drives, DVD/RW, fan controller, start-up panel.
All done and ready to RUMBLE! (I did do a little more wire management)
