Add the swiftech hold down bracket, add your spacers, line up the holes. very slowly to compress the styrofoam evenly. All done? I hate this part! Now remove the block look at the thermal paste if you had good contact?Add more thermal paste add reset it. Better safe then sorry.
Using the 3/4 inch thick pipe insulation (7/8 ID). Cut one side about 2 inches up.Slide the pipe insulation over the lines (tight fit) make sure the lines are a few incheslonger then you need.
Slide it all the way on tight to the top of the block.squeeze the 2 inch cut together ad duct tape.Cut a piece of the 1 1/2 in weather stripping (sticky back) wrap it around the joint.Folding it slightly onto the swiftech water block.Then duct all the edges very very tight. (remember air is not your friend LOL)Add motherboard to case.
